Скачать инструкцию



Фрагмент инструкции: руководство пользователя BLAUPUNKT TRAVELPILOT-RGS05-LATIN-1

Подробные указания по применению содержатся в руководстве пользователя.

Important: You must also comply with all safety instructions given by the auto manufacturer (alarm system, vehicle immobilizer, airbag)! Before drilling holes for mounting the equipment or laying the wiring, make sure that no existing wiring or auto parts (such as the petrol tank, fuel line) will be damaged. Use wire bushings on sharp-edged holes. In order to avoid any interference, lay all wiring far enough away from the wire harnesses. Equipment fuses: Basic unit: GPS receiver: 5 A wire fuse 5 A miniature fuse 5 A wire fuse Magnetic field sensor (electronic compass) Note: You must determine the optimum mounting location for the magnetic field sensor in each vehicle individually. Before permanently installing the magnetic field sensor, attach it temporarily and then test the chosen location with the installation and calibration CD-ROM to make sure everything operates correctly. The magnetic field sensor must be installed in the passenger room. It determines the driving direction by measuring the horizontal earth magnetic field component. Since the earth magnet field is relatively small, you must ensure that there is no magnetic or electromagnetic interference affecting the magnet field sensor at the chosen mounting location. Use the enclosed mounts to attach the magnet field sensor to a window which cannot be opened or, especially where estate wagons or liftback cars are concerned, mount it without fasteners underneath the inside roof lining using double-sided sticky tape. Note: If the magnetic field sensor is mounted in the direct vicinity of an AM radio antenna integrated into the rear window, it may cause occasional interference in the radio reception in the long wave range...
Copyright © 2005 - 2012 - Diplodocs - Все права защищены.
Торговые марки принадлежат их соответствующим владельцам.