11b/g Wireless VoIP Station Gateway Quick Start Guide Version 3. 60 Edition 1 8/2006 P-2302HW/HWL-P1 Series Quick Start Guide 1 Connect the Hardware 1 WAN: Use an Ethernet cable to connect the DSL modem to this port. 2 LINE (P-2302HWL models only): Use the green PSTN line cable to connect the TEL or PHONE jack on a splitter to this port. If no splitter is provided connect the the telephone jack to this port. Note: When the P-2302HWL-P1 does not have power, only the phone connected to the PHONE 1 port can be used for making calls. Ensure you know which phone this is, so that in case of emergency you can make outgoing calls. 3 ETHERNET: Use an Ethernet cable to connect a computer to this port for initial configuration and/or Internet access. 4 PHONE 1-2: Use telephone cables (and any telephone adaptors provided with your P-2302HW/HWL-P1) to connect your telephones to these ports. If you only have one telephone, you should use port 1. 2 P-2302HW/HWL-P1 Series Quick Start Guide 5 POWER: Use the power adaptor provided with your P-2302HW/HWL-P1 to connect an appropriate power source to this socket. 1 LEDs (Lights) · The POWER light blinks during start-up and is green once the P-2302HWL-P1 is ready. · Each ETHERNET light turns on if the corresponding ETHERNET port is properly connected. The lights blink when the P-2302HWL-P1 is sending or receiving data through the corresponding ETHERNET port. · The WAN light stays on if a physical connection with your DSL modem exists. The INTERNET light stays on when Internet access is available. · The PHONE lights stay on when your SIP account is registered and they blink if the receiver is off the hook. · The WLAN light turns on when the wireless LAN is ready. It blinks when the P-2302HWL-P1 is sending/receiving data through the wireless LAN. If none of the LEDs are on, turn the device off and recheck your hardware connections...