00 12/2006 Edition 2 Table of Contents ENGLISH DEUTSCH FRANÇAIS ITALIANO SVENSKA 1 19 37 55 73 91 Copyright © 2006. All rights reserved. ENGLISH Overview The NSA-2400 (the NSA) is a network storage device for file sharing, data backup and data protection in small (home) offices and/or medium-sized offices. This guide shows you how to: 1 Install hard drives 2 Make NSA Connections 3 Access the NSA using NDU (NSA Discovery Utility) or your web browser 4 Set up the NSA using the wizard 5 Map the NSA to a network drive from any computer Note: See the User's Guide for more details and specifications on the NSA. Requirements You need the following before you start: · NSA · Included CD containing the NDU (NSA Discovery Utility) and Genie Backup Manager · Power cord and power supply (external) · 8-wire Ethernet cable for Gigabit Ethernet · Up to four SATA-1 or 2 (Serial Advanced Technology Attachment) compatible hard disk(s) · Screwdriver to install the hard disks in the disk trays · USB cable (optional: you only need this if you want to expand storage capacity by connecting compatible USB 2. 0 drives · Computer with Network Interface Card (NIC) and TCP/IP installed · Network access device such as a switch or hub. 1 ENGLISH 1 Install Hard Drives Note: Hard drives are NOT hot swappable. The NSA must be turned off before you remove or install hard drive(s). 1 Pull the tab on the left of the front door of the NSA to open it. 2 Pull out the latch and grip the sides of the tray to remove disk tray 1. Be careful not to break the latch. Disk bay 1 is labelled on your NSA (the top-left bay). 3 Place the disk tray on a flat surface with the panel facing up. Place a hard disk with the screw holes facing up on the same surface and slide it into the disk tray. Secure it with the screws as shown...