Organizations can restrict access to the walk-up features of a Xerox device. This ensures only authorized users are able to copy, scan, e-mail and fax information. The key benefit of this solution is its two-factor identification requirement. Users must insert their access card and enter a unique Personal Identification Number (PIN) at the device. This provides added security in the event that a card is lost or stolen. Once validated, a user is logged into the Xerox device for all walk-up features. The system allows for functions to be tracked for an added layer of security. The Xerox Common Access Card enablement kit integrates with Xerox multifunction printers and existing common access and personal identity verification cards and readers. This guide explains how to install and configure the Common Access Card solution. It identifies the resources and equipment required to complete a successful installation. Should you require any further information, please contact your Local Xerox Representative. Xerox Common Access Card Common Access Card Installation Guide 5 Introduction Compatibility This solution is compatible with the following product and configurations: Configuration Xerox WorkCentre 5030/5050 Multifunctiona Xerox WorkCentre 5632/5638/5655/5665/5675/5687 Multifunctionb Xerox WorkCentre 5135/5050 Multifunction Xerox WorkCentre 5735/5740/5755/5765/5775/5790 Multifunction a. Software Level 05. xxx 21. xxx 25. xxx 21. xxx 06x. xxxxx b. If your machine is a WorkCentre 5030/5050 and has software level 05. xxx, the Common Access Card software can not be installed without first upgrading the machine software. Please contact your Xerox Representative for details. If your machine has a different software level, a different Installation Guide is required...