Note: The control panel and associated menu entries are only available if the supported Apogee hardware is installed correctly in your system. For further information on installing the Apogee device, please refer to the manuals supplied with your Apogee device. To open the Apogee control panel: m Choose Options > Audio > Open Apogee Control Panel from the main menu bar. The Apogee control panel automatically displays the parameter set that applies to your connected audio device. See the following section for details on the Ensemble control panel. See "Duet Control Panel" on page 6, for a full description of all Duet parameters. 1 Ensemble Control Panel The Ensemble control panel offers two parameter types: Global and Unit. Â Global parameters are only relevant if more than one Ensemble device is connected to your system; they define how several devices work together. Â Unit parameters configure individual hardware units. Global Parameters The Global parameters at the top of the Apogee hardware control panel define how multiple Apogee Ensemble hardware devices work together. Unit Selection The Unit Select menu defines the hardware device (when multiple units are connected). The parameters of the selected device are displayed in the Unit tabs below. Activate the Identify Unit checkbox (next to the Unit Select menu) to illuminate all LEDs on the corresponding hardware interface. Loop Sync Loop Sync facilitates the proper clocking of multiple units. It allows simple reconfiguration of clock signals, accommodating non-synchronous digital inputs on all connected units. Choose the hardware unit that should be used as the clock master from the Loop Sync Master menu. Once a device is designated as master, all other units are automatically locked to its word clock...