Failure to follow these instructions could result in damage to your equipment and may void your warranty. Replacing the keyboard in your computer requires three basic steps: · Turn off the computer. · Remove the keyboard. · Install the new keyboard. Note: A video version of the installation instructions is available at http://www. apple. com/installparts Tools Required · Jeweler's flat-blade screwdriver · Phillips screwdriver Electrostatic Discharge (ESD) Static electricity, a normal and natural phenomenon, builds up on your body as you walk around. You experience an electrostatic discharge (ESD) when you touch an object and feel a spark. ESD can cause damage to the internal components of your computer. To avoid ESD damage, read and follow all instructions. 073-0581 Removing the Installed Keyboard 1 2 Place your computer on a clean, flat surface. Shut down your computer, then disconnect all cables. Turn over the computer and with a flat-blade screwdriver or a coin, turn the battery screws counterclockwise to release the battery door. Pull the battery pull tab to remove the battery. 3 Release the keyboard by sliding the two plastic tabs away from the display. Note: If the keyboard does not pop up, it may be locked. Locate the keyboard lock next to the num lock key. Use a flat-blade screwdriver to turn the lock a half turn in either direction until you can slide the plastic tabs away from the display. Tab Keyboard Lock Tab 2 - iBook Keyboard 4 Lift up the keyboard, flip it over, and lay it on the palm rests and trackpad. To avoid ESD damage, touch a metal surface inside the computer. 5 If necessary, flip up the wire bracket, and remove the AirPort Card from its connector. (It is not necessary to disconnect the AirPort antenna cable...