0) AirPort Extreme Card Replacement /Installation Instructions Follow the instructions in this sheet carefully. Failure to follow these instructions could damage your equipment and void its warranty. Note: Written and video instructions covering customer-installable parts are available at http://www. apple. com/installparts/. Tools Required · #2 Phillips screwdriver. Opening the AirPort Access Door 1. Save all open documents, quit all open applications, and shut down the computer. Press the optical drive door in on one side and pull the door open on the other side to access the AirPort access panel. (Figure 1) Figure 1 3. Loosen the captive screws on the AirPort access panel using a Phillips screwdriver. (Figure 2) Figure 2 4. Remove the access panel. eMac (ATI Graphics) and eMac (USB 2. 0) AirPort Extreme Card - 2 Removing the Installed Card 1. Untuck the clear plastic tab on the AirPort Extreme card. (Figure 3) Figure 3 2. Pull the AirPort Extreme card out of the slot a little bit to access the antenna cable. (Figure 4) Figure 4 eMac (ATI Graphics) and eMac (USB 2. 0) AirPort Extreme Card - 3 3. Disconnect the AirPort Extreme cable from the port on the card, then completely remove the card from the slot. (Figure 5) Figure 5 eMac (ATI Graphics) and eMac (USB 2. 0) AirPort Extreme Card - 4 Installing the Replacement Card 1. The original AirPort Card can not be used in this computer. You must use the AirPort Extreme card. (Figure 6) Note: Previous models of eMac used the original AirPort card. For compatibility information, see AppleCare Knowledge Base article 107440: AirPort Extreme Card: Compatible Macintosh Computers. Figure 6 2. Insert the AirPort Extreme Card, barcode facing up into the AirPort Extreme card slot. (Figure 7) Figure 7 eMac (ATI Graphics) and eMac (USB 2. 0) AirPort Extreme Card - 5 3. Attach the antenna cable firmly to the port on the end of the card...