Both timer channels can be used at the same time. When using both timer channels, simply press the T1 or T2 button to note count down time remaining. Non-flashing (T1 or T2) indicates the count down time of the channel being displayed. 2 CHANNEL JUMBO DISPLAY CLOCK TIMER INSTRUCTION MANUAL MODEL:TR118 TIMER BUZZER ALARM 1. When timer counts to 00H, 00M and 00S, timer buzzer alarm will sound and timer will begin to count up in seconds with respective non-flashing timer channel indicator appearing in display. Timer buzzer will be stopped by pressing any button. Buzzer will automatically turn off in 60 seconds. Count-up timer continues to operate until stopped. Count-up timer in alarm mode can be stopped by pressing any button. Press Clear button to reset display to zero. If both channels are counting down, when time expires in both channels within a minute of each other and the alarm has not been turned off, the alarm for the just expired timer will sound with the other timer channel flashing in the display. Turn off by pressing the START/STOP button. The other channel alarm will sound at the completion of cycle, and the indicator will count up. Press START/STOP button to turn off. DUAL-TIMER T1 CLOCK 6. T2 7. H M S C CLEAR START STOP MEMORY 8. TIMER MEMORY RECALL BATTERY COVER MAGNET 1. After timer buzzer alarm stops, press START/STOP button once to recall preset timer time. Press START/STOP button again to start timer. COUNT-UP/STOPWATCH TIMER PLASTIC CLIP MODEL NO. TR118 1. Press desired timer channel button. Press CLEAR button to clear display. Press START/STOP button and time will begin to count-up in 1 second resolution. Press START/STOP to stop count-up timer. If you wish to restart timing process, press START/STOP button again. To turn timer off, press START/STOP button and then Clear button...