LF/FF button Feeds paper line by line when pressed and released. Ejects a single sheet or advances continuous paper to the next top-of-form position when held down. Paper Out light On when no paper is loaded in the selected paper source or when paper is not loaded correctly. Flashes when paper has not been fully ejected or a paper jam has occurred. Tear Off (Font) button** Advances continuous paper to the tear-off position. Feeds continuous paper backward from the tear-off position to the top-of-form position. Load/Eject button Loads a single sheet of paper. Ejects a single sheet of paper if a sheet is loaded. Loads continuous paper from the standby position. Feeds continuous paper backwards to the standby position. Pause button Stops printing temporarily, and resume printing when pressed again. When pressed fo three seconds, turns on the Micro Adjust mode*. To turn off, press again. Pause light On when the printer is paused. Flashes when the printe is in the Micro Adjust mode*. Flashes when the print head has overheated. *Micro Adjust mode When you hold down the Pause button for three seconds, the printer enters the micro adjust mode. In this mode, you can press the LF/FFD and Load/EjectU buttons to adjust the top-of-form or tear-off position. See Chapter 2, "Using the Printer. " **Font select In the Micro Adjust mode, you can select the font to use for printing by pressing the Tear Off button. The Tear Off lights turn on, off or flash to indicate the selected font. ® 9-Pin Dot Matrix Printer All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION...