Front View (with external-diskette drive) Brightness control Suspend indicator Battery indicator Internal speakers Hard-disk drive Liquid crystal display (LCD) System-status indicators Built-in microphone TrackPoint Volume control PC Card eject buttons PC Card slots Click buttons UltraslimBay LCD latch Video-out connector Infrared port Headphone jack Microphone/line-in jack External-diskette drive Diskette eject button External-monitor connector Parallel connector System-expansion connector Serial connector Power jack Power switch Reset switch Universal serial bus (USB) connector Modem connector (optional) Rear View External-input-device connector Security keyhole Copyright IBM Corporation 1998 1 Electrical Safety DANGER Electrical current from power, telephone, and communication cable is hazardous. To avoid shock hazard, connect and disconnect cables as shown below when installing, moving, or opening the covers of the product or attached devices. The 3-pin power cord must be used with a proper outlet. Setting Up Your Computer You are now ready to assemble and start your computer. 1 If you want to connect a printer to your computer, open the connector cover. Connect one end of the printer cable to the parallel connector and the other end to your printer. Then power on the printer. To Connect Turn everything OFF. Attach all cables to devices. Attach the signal cables to receptacles. Attach the power cord to an outlet. Turn the device ON. 2 If you want to use the CD-ROM and the diskette drive at the same time, you can attach the diskette drive to the external-diskette-drive connector as follows: Insert the diskette drive in the diskette-drive enclosure and connect it firmly 1. Connect the cable to the external-diskette-drive connector 2. To Disconnect Turn everything OFF...