PS/2 mouse and keyboard connector Parallel connector Battery pack Hard disk drive Serial connector Infrared port Power switch S-video jack Externalmonitor Power jack Universal serial bus(USB) connector connector Modem connector Headphone jack Line-in jack Microphone jack PC Card slots PC Card eject buttons Audio volume control Diskette drive Security keyhole TrackPoint buttons Internal speakers CD-ROM drive Notes: 1. The internal speakers are located on the lower edge of the LCD or on the front ends of the computer, depending on the model. The modem feature is available only on select models. © Copyright IBM Corporation 1999 1 Bottom View Tilt feet Memory door Battery-pack latch Bay LED UltraBay FX device lock To Connect Turn everything OFF. First, attach all cables to devices. Attach the signal cables to the receptacles. Attach the power cord to an outlet. Turn the device ON. To Disconnect Turn everything OFF. First, remove the power cord from the outlet. Remove the signal cables from the receptacles. Remove all cables from device. System-expansion connectors Note: In the U. , by law: The telephone line cable must be connected after the power cord. Electrical Safety Notice The power cord must be disconnected after the telephone line cable. Setting Up Your Computer DANGER Electrical current from power, telephone, and communication cables is hazardous. To avoid shock hazard, connect and disconnect cables as shown below when installing, moving, or opening the covers of this product or attached devices. The 3­pin power cord must be used with a properly grounded power outlet...