What's in the box What's in the box A Your TomTom RIDER 1 2 3 4 5 6 a Touchscreen b On/Off button c Memory card (SD card) slot d USB connector e Charging connector f Reset button B A memory card (SD card) C Cardo scala-riderTM Bluetooth® headset D RAM MountTM mounting kit 2 E Holder and security strap F TomTom RIDER case G Home Charger H Documentation pack I Battery cable J USB cable 3 2. Using your TomTom RIDER Using your TomTom RIDER Switching on 1. Open the compartment on the bottom of your TomTom RIDER. Push the memory card into the memory card slot. Press and hold the On/Off button for 2 seconds, or until your TomTom RIDER starts. The first time you switch on your TomTom RIDER, it may take up to 20 seconds to start. To switch off your TomTom RIDER, press and hold the On/ Off button for 2 seconds. Setting up First, you have to answer a few questions to set up your device and your Cardo scala-riderTM headset. Answer the questions by tapping the screen. You will use the touchscreen for everything you do with your TomTom RIDER. Follow the instructions to establish a Bluetooth connection between your TomTom RIDER and your Cardo scala-riderTM headset. Once you have answered the questions, your TomTom RIDER will display the Driving View. The screen is shown in black and white until your TomTom RIDER locates your current position. Charging your TomTom RIDER Before you use your RIDER for the first time, it's a good idea to charge it fully using the home charger, which takes about 2 hours. There is no charging light on your RIDER. To check the battery status and see when your RIDER is charging, switch on your device and tap the bottom righthand corner of the screen in the Driving View. The battery status is shown on the next page...