Installation Installation 1 2 3 4 2 5 6 5 6 + 7 2 SEC 8 1 2 3 3 1 2 3 180° 4 5 4 2. What's in the box What's in the box a Your TomTom XL b EasyPortTM holder c Car charger d USB cable e Documentation pack 5 3. Before you start Before you start Switching on and off Install your TomTom XL navigation device in your car following the instructions in the installation section at the start of this book. To switch on your navigation device, press and hold the On/Off button until you see the start-up screen. The first time you switch on your device, it may take a short time to start. To set up your device you need to answer a few questions by tapping the screen. Device not starting In rare cases, your TomTom XL navigation device may not start correctly or may stop responding to your taps. First, check that the battery is properly charged. To charge the battery, connect your device to the car charger. It can take up to 2 hours to fully charge the battery. If this does not solve the problem, you can reset the device. To do this, press and hold the On/Off button for 15 seconds and release the button when your device begins to restart. Charging your TomTom XL Before you use your XL for the first time, it's a good idea to charge it fully. The battery in your TomTom XL navigation device charges when you connect it to the car charger or to your computer. There is no charging light on your XL. To check the battery status and see when your XL is charging, switch on your device and tap the bottom righthand corner of the screen in the Driving View. The battery status is shown on the next page. When you connect your device to a computer, you are asked if you want to connect to the computer. If you select No and then do not tap the screen within three minutes, the device will automatically switch off...