Therefore, the model you bought may not support some of the functions or settings described hereinafter. About set-up To ensure your own safety and safe operation of the equipment, observe the following instructions thoroughly. TV sets require sufficient ventilation to prevent their components from overheating, which will cause failure. Do not block the ventilation openings at the rear. If you place your TV set in a specific unit, make sure there is enough space for unhindered air circulation. Do not place the TV set in the close vicinity of a heater. 5 cm 10 cm 10 cm 10 cm 10 cm In the following cases, we recommend that you pull out the mains connector: 1. During a thunderstorm. In such a case, it is advisable that you also disconnect the TV set from the aerial socket. When odour or smoke emanates from the set. Further information: The TV set shielding is sufficient to prevent X-radiation to the exterior. The accelerator voltage does not exceed 26 kV. Any operation performed by a non skilled person, change of high voltage or replacement of the teletube by a model not complying with the manufacturer specification are likely to cause considerable increase in X-radiation. A TV set modified in such a way no longer complies with the manufacturer specification and shall not be put in operation again. About cleaning The screen is to be cleaned with liquid glass cleaners. · Never use abrasive products. · Clean the front side and the housing with a soft cloth soaked with neutral cleaner. Do not use solvents, such as white spirit or alcohol-based cleaning products since they are likely to deteriorate your equipment. · At regular intervals, clean the ventilation grids at the rear of the TV set. The On/Off switch is either fitted laterally or the front side of the set...