Video 2: Controls cable and satellite television set-top boxes. Video 3: Controls televisions and other video displays. For example, if you have inserted a disc in your CD player and you would like to skip ahead three tracks, but you then find that the volume is too loud, you would follow this procedure: AVR Selector: Press this button to switch the remote to the codes that operate the receiver. Input Selectors: Press one of these buttons to select a source device, which is a component where a playback signal originates, e. , DVD, CD, cable TV, satellite or HDTV tuner. This will also turn on the receiver (if it is not already on) and switch the remote to the codes that operate the source device. AM/FM Button: Press this button to select the tuner as the source, or to switch between the AM and FM bands. Press the CD Input Selector to switch to the codes that control your CD player. 6-Channel Input Selector: Press this button to select the 6-Channel Inputs as the audio source. The receiver will use the video input and remote control codes for the last-selected video source. Press the Play Button (in the Transport Controls section) if the disc is not already playing. EzSet (SPL) Button: Press this button to run the EzSet output-level calibration procedure. Make sure to point the remote toward the receiver during EzSet. Press the Skip Up Button three times to advance three tracks. Press the AVR Button so that you can access the Volume Controls. Press the Volume Down Button until the volume level is satisfactory. Any given button may have different functions, depending on which component is being controlled. The buttons are labeled with some of these functions, with the receiver's functions shown in white or gray, and the DVD player's functions shown in blue. For example, the Sleep and DSP Surround Buttons are labeled for use as Channel Up/Down Buttons when controlling a television or cable box...