Фрагмент инструкции: руководство пользователя LOGITECH E2500Подробные указания по применению содержатся в руководстве пользователя. FAQs
Where can I find more information?
Commander Help You can press the F1 key from any screen in the Alert Commander to access the online Help system. Knowledge Base Troubleshooting help is available at www. logitech. com/support Customer Support Call 1. 4543 What do I do if the power supply cable (yellow connector) is too short?
Camera Reset Instructions
Troubleshooting camera connection:
What if camera/video disappears? 1) Test another outlet for your camera, perhaps one closer to your PC. 2) Verify that the camera power supply and the network bridge are plugged directly into a power outlet and not a power strip. 3) Check firewall settings or press the F1 key in Commander Software for additional help. 4) Go to Settings > Cameras > Add/Find > Find Cameras. 5) Reset the camera. See instructions in "Camera Reset Instructions. "
HELP
To lengthen, either use a coupler or purchase a longer ethernet (CAT-5e) cable. Insert a paper clip into the reset hole located on the back of the camera and press gently and then release. Logitech Alert Video Security System
TM
Refer to System Requirements Guide. Quick-start guide
GETTING TO KNOW
TM 0i Logitech Alert 700i/75 irements
Quick-start guide
System Requ & Support Guide
Want to see more FAQs?
Go to www. logitech. com/security/support
If the camera does not appear after reset, go to Settings > Cameras > Add/Find > Find Cameras. If the camera still does not operate, contact technical support. Resetting the camera will restore the camera to factory settings. However, it will not delete video recorded on the microSD card... |
Copyright © 2005 - 2012 - Diplodocs -
Все права защищены. Торговые марки принадлежат их соответствующим владельцам. |