Setting up First, you have to answer a few questions to set up your device and your Bluetooth headset module. Answer the questions by tapping the screen. You will use the touchscreen for everything you do with your TomTom RIDER. Follow the instructions to establish a Bluetooth connection between your TomTom RIDER and your Bluetooth headset module. See the Bluetooth headset module section below for more information about your Bluetooth headset module. Once you have answered the questions, your TomTom RIDER will display the Driving View. The screen is shown in black and white until your TomTom RIDER locates your current position. Once this is done, the Driving View is shown in full colour. Locating your current position Your TomTom RIDER must be outside to be able to locate your current position. The first time you start your RIDER, it takes up to 5 minutes for the device to find your current position. In future, your position will be found much faster, normally within a few seconds. If your RIDER takes longer than 5 minutes to locate your current · · ·7 · · · position, make sure that you are in an open place without tall buildings or trees around you. Your RIDER does not transmit your location, so others cannot use it to track you while you are driving. Note: Before driving with your TomTom RIDER, we recommend that you charge it fully using the home charger. TomTom RIDER uses a GPS receiver to locate your current position. For more information about GPS, see How does navigation work? on page 67. Bluetooth headset module 1. Indicators 2. Volume controls 3. On/Off button 4. Charging connector 5. Headset connector Before you can use your Bluetooth headset module with the helmet headset, you must charge the headset module using the home charger. Connect the headset cable to the Bluetooth headset module and then to the helmet headset or standard headset. Attach the Velcro pads provided to the inside of your helmet...