Follow the installation instructions in this guide. Turn off your display and computer. Unplug the DC power cord from the power adapter, and unplug the DVI, USB, and FireWire cables from the computer. Carefully pull the entire display cable assembly through the hole in the stand. Place a soft, clean towel or cloth on a desk or flat surface. Holding the sides of the display, carefully lay it down so the screen is flat against the towel or cloth on the desk or surface. Using the hex tool that came with this kit, loosen the screws that attach the stand to the back of the display as shown in the illustration. Remove the screws and stand and put them in a safe place in case you want to reattach the stand. Display cable Stand 1 2 3 Screws Hex tool ¤ ® 3 4 5 Choose the right screws and bumpers for your size of display. Remove the screws and bumpers from their plastic bag. Snap the bumpers into place on each side of the mount adapter. Bumpers Mount adapter 6 Place the mount adapter over the slot on the back of the display as shown in the illustration below. Use the hex tool to screw the mount adapter to the display. Display cable Screws Mount adapter Hex tool 7 8 Follow the instructions included with the VESA-compatible mounting solution to attach your display to the mount. Plug the DC power cord in to the power adapter, and plug the DVI, USB, and FireWire cables in to the computer...