, "PAUSE" appears on the display and the Recording/playing lamp flashes. To resume recording Y Canceling Playback To stop Y Standby Mode and Display Shut Off If the recorder is stopped or paused for 60 minutes or longer during recording or playing, it goes into Standby (power-save) mode, and the display shuts off. To exit Standby mode and turn on the display, press any button. Press the REC button again. , Recording will resume at the point of interruption. Press the STOP button. , The recorder stops in the middle of the file being played. To resume playback Notes Press the PLAY button again. , Playback will resume at the point of interruption. When you play back a file in the date subfolder without choosing a specified file, the recorder will play back all the files in the selected date subfolder from filename "01". When you play back a file immediately after recording the file, only the most recently recorded file will be played back. Setting Time/Date (TIME) If you have set the time and date, information as to when a sound file was recorded is stored automatically with that file. The time and date must be set to enable management of files in folder S (VN-240/VN-240PC/ VN-480/VN-480PC/VN-960PC), for the alarm playback function, and for the timer recording (VN-480/VN-480PC/VN-960PC). When you install batteries for the first time or each time you replace the batteries, the hour indication will flash. In such a case, be sure to set the time and date by following steps 5 through 9 described below. · Press the area that the arrow points to. · Do not force the clip wider, as it may break. Notes on the Folders The recorder has four folders: A, B, C, and S. To change the folder selection, press the FOLDER button while the recorder is stopped...